Determine whether your SAP is MDMP, Non-Unicode or Unicode

-
As per  http://scn.sap.com/thread/246990



Hi Sam,

Run report RSCPINST and select /Current NLS config button/.
It will show you current NLS settings, and on very top of it display:
1. Non-unicode system - meand single CP or blended CP inst;
2. MDMP installation - it's an MDMP box
3. Unicode inst - guess what 

Checked it on MDMP, Unicode & BCP systems here rel 4.7 ent ABAP.

Thanks.

//alak

Comments

Post a Comment

Popular posts from this blog

SAP Fiori Launchpad Activation via Task List (STC01)

-
Two good references:

http://help.sap.com/fiori_bs2013/helpdata/en/bf/d1b053a647e842e10000000a4450e5/frameset.htm
http://www.sapnwnewbie.com/2015/12/automating-frontend-configuration-of.html

Following are the task available on STC01 to perform Fronend setup:
SAP_FIORI_LAUNCHPAD_INIT_SETUP - To activate launchpad OData and HTTP services on an SAP Gateway system (frontend)SAP_SAP2GATEWAY_TRUSTED_CONFIG - To create a trusted connection from an SAP system to SAP Gateway.SAP_GATEWAY_ADD_SYSTEM -  To connect an SAP system (backend) to an SAP Gateway system (frontend).SAP_GATEWAY_ADD_SYSTEM_ALIAS - To create a system alias for an existing remote function call destination (to backend).SAP_GATEWAY_ACTIVATE_ODATA_SERV - To activate multiple OData services. OData services are required to initially set up the SAP Fiori Launchpad and the SAP Fiori Launchpad designer.SAP_BASIS_ACTIVATE_ICF_NODES - To activate multiple HTTP Services (ICF). The SAP Fiori Launchpad uses the User interface add-on for SAP …
Read more

Windows 2003 W2k3 Getting Current MTU Size

-
Image
I am trying to get the current running MTU sieze configured on a windows 2003 (W2K3) server. Got a ref from here : http://superuser.com/questions/37686/how-to-tell-what-mtu-is-being-used-in-windows-xp

But during running the netsh command, got some error saying 'command not found'. It turns out the real command for ipv4 is not ipv4 but just 'ip' and ithe one i'm trying to use is not 'subinterfaces' but just 'interface'. SO my final command that wokred as below:


netsh interface ip show interface
And the result shown is as below, and you can get hell lot of details. :)



/alak
Read more